Sample

Powered Drum Transporter with Powered: travel, lift, clamp & rotation

• Capacity: 800 lbs. (360kg)
• Single- or two-stage mast for lift heights from 48″ to 144″ (122 cm to 366 cm) of lift from floor to bottom of a 34.5” (87.6cm) tall drum in the vertical position

• CR side clamp rotator lined with white non-marking rubber to securely grip a
  plastic, fiber, or steel drum from 20” (50.8cm) to 24” (60.9cm) in diameter.
• Clamp Rotator rotates 360 degrees left or right for dispensing
• Provides approximately 10” (25.4cm) of reach from the front of the base to the back of the drum
• Remote rotation and clamping functions provided in magnetic backed control box on coil cord, clamping functions with red dead-man switch to prevent accidental dropping of drum
• Battery: Deka 12-D85-9 Wet Cell, 24 Volt, 340 A.H. industrial battery with Anderson 175SB connector
• Key on/off switch & Battery Discharger Indicator with gauge type with hour-meter
• Electronic speed controller is equipped with three travel profiles to allow for factory customization of travel parameters. Maximum travel speed can be preset for speeds between 0.93 and 2.8 mph. Unless otherwise specified at time of order, maximum travel speed will be factory preset at 1.8 mph in the forward and reverse direction.
• Thumb control forward and reverse switch with creep speed provided by a snail button, reversing safety switch with handle lockout positions and horn button located in the tiller handle
• Load Wheels: (2) tandem polyurethane 3” dia. x 4” wide
• Drive Wheel: (1) polyurethane or rubber 9” diameter x 2.75” wide
• PVC Foot Guard on rear of Drum-Hauler behind drive tire
• Stability Caster: (2) polyurethane 4” diameter x 1” wide
• Finish: Safety orange powder coating
• Base Dimensions: 28.5” (72 cm) overall drive frame width with narrow 20.5” (52 cm) front mast plate and 54” (137.2 cm) length
• 1-year warranty, 2-year warranty on drive motor, 5-year warranty on wet cell batteries
• Made in USA